NEC N8800-162F User Manual page 74

3-6 Linux Setup and Operation
4 Repair Mirroring Arrays
5 Delete Mirroring Arrays
6 Remove Disk Partitions
7 Make Striping Array
8 Delete Striping Array
c Configurations
q Quit
Command: 1 (Check if the disk specified is isolated from the RAID
configuration.)
[List RAID Arrays]
Name Partition
=======================================================
< Mirroring Array (RAID1)>
md0 /boot
md1 swap
md2 /
md3 /var/crash
(After verifying the isolation of the specified disk from the
RAID configuration (verifying no partition of the specified disk
is in Member), replace the hard disk. Wait approximately five
minute before the system starts to resynchronize. If there is
no automatic synchronization, manually restore the disk with the
below procedure.)
Command action
1 List RAID Arrays
2 List Internal Disks
3 Make Mirroring Arrays
4 Repair Mirroring Arrays
5 Delete Mirroring Arrays
6 Remove Disk Partitions
7 Make Striping Array
8 Delete Striping Array
c Configurations
q Quit
Command: 2
system.)
[List Internal Disks]
Slot Name [use]
============================================================
1 sda (sdq)
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 sdi (sdr)
10 -
11 -
(Label)
( - )
( - )
( - )
( - )
(Check if the replaced disk is recognized by the
Informati
on
[4]
[4]
(RAID1)
(RAID1)
(RAID1)
(RAID1+0)
(RAID1+0)
Status Member
SIMPLEX (1)sda1
SIMPLEX (1)sda2
SIMPLEX (1)sda3
SIMPLEX (1)sda5
(RAID1)
(RAID1)
(RAID1)
(RAID1)
(RAID1+0)
(RAID1+0)
(Vendor/Model/Serial)
AAA/BBB/#CCC
AAA/BBB/#CCC
path
h5c0t12810
h6c0t12810