NEC N8800-162F User Manual page 157

Installing and Using Utilities 5-21
When [ft] Tree Appears on Date Viewer in an Incorrect Manner
If you open a DataViewer immediately after the system starts up, the tree or the state of a
DataViewer may not be displayed correctly due to high load of the system. Please restart a
DataViewe again in about 5 minutes.
When [ft] Tree Appears on Date Viewer in the Ethernet Board
When it chose the [Ethernet Board] of the [ft] tree, some information is displayed with "unknown"
or "0:0:0:0:0:0".
About the state of the network, please use a vndctl command (NIC setting tool).
# vndctl status
About the packet information, please refer to [Network Information] of the [ESMPRO] tree.
Ethernet Adapters You Do Not Use
When the cables are not connected to the Ethernet adapter ports, NEC ESMPRO Agent determines
that the ports are faulty (does not have any media), and the status color of [ft] – [PCI module] –
[Ethernet Board] of the Data Viewer turns red (abnormal). The server status color of Operation
Window also turns red (abnormal).
As to the ports of the unused Ethernet adapeter, connect the unused port of PCI module 0 and that of
PCI module 1 with a cross cable.
DataViewer display when only one of the PCI modules (IO modules) is operating
When only one of the PCI modules (IO modules) is operating (non-dual configuration), the SCSI
enclosure or mirror disk status cannot be displayed normally.
To check if the dual configuration is changed to the simplex operation mode, check the event log,
AlertViewer log, or the status color of PCI module of DataViewer.