Removing A Pci Option Board - NEC EXPRESS5800/120Re-2 Service Manual

14. Reinstall the top cover on the system chassis. See Top Cover Installation
found earlier in this chapter.
15. Plug in the system power cord(s).
16. Power on the server and verify that POST displays no error messages.
17. If POST displays an error message, take note of the message and see the
POST error messages listed in Chapter 5.
18. Run the BIOS Setup Utility. Select "Yes" for [Advanced] → [Reset
Configuration Data]. This setting is required to change the hardware
configuration data.
19. Run the configuration utility (if applicable) for the installed card, and set up
the card. For details, see the manual provided with the card.
20. If a PCI board (e.g., a disk array controller, SCSI controller, or LAN card)
with a bootable device connected to it is installed, the boot priorities must be
reconfigured. After installation of the PCI board, run the BIOS setup utility,
select [Boot] → [Boot Device Priority], and set the new boot priorities. (See
Chapter 3).

Removing a PCI Option Board

Remove a PCI board in reverse order of the installation steps. After the PCI
board is removed, start the BIOS setup utility, select [Boot] → [Boot Device
Priority], and set the new boot priorities. (See Chapter 3).
4-32 Disassembly and Reassembly