Configuring Port Parameters - Allied Telesis AT-FH812u User Manual

AT-FH812u and AT-FH824u Software
Configuring Port
Parameters
16
Select Administrative Status Control from the Port Configuration screen to
configure any port on the hub. The following menu shows the configuration
options. In addition to the functional parameters listed in Figure 10, note that you
can also enable/disable any port. Table 9 lists and defines the Port Administration
Status control parameters.
------------------------------------------------------------
Port Administration Status Control (1 - 12)
Hub ID : 1
Port Admin State
------------------------------------------------------------
1. Enabled
2. Enabled
3. Enabled
4. Enabled
5. Enabled
6. Enabled
7. Enabled
8. Enabled
9. Enabled
10. Enabled
11. Enabled
12. Enabled
<APPLY>
Use TAB or Cursor keys to move, <Space> to select.
------------------------------------------------------------
Figure 10 Port Administration Status Control
If a port is disabled by an intrusion action, you must disable it manually in the
Administration Status menu, then re-enable it to restore the connection. See
Configuring Port Security on page 19.
Link State Partition
Connected Not-Partition
Connected Not-Partition
Connected Not-Partition
Connected Not-Partition
Connected Not-Partition
Connected Not-Partition
Connected Not-Partition
Connected Not-Partition
Connected Not-Partition
Connected Not-Partition
Not-Connected Not-Partition
Connected Not-Partition
<OK> <CANCEL>
The administrative status of port.
Note
Mode Speed
Auto 100M
Auto 100M
Auto 100M
Auto 100M
Auto 100M
Auto 10M
Auto 100M
Auto 10M
Auto 100M
Auto 100M
Auto 10M
Auto 100M
<PORT_13_24>