Rmon Configuration - Allied Telesis AT-FH812u User Manual

AT-FH812u and AT-FH824u Software
RMON
Configuration
20
Use the RMON Configuration screen (Figure 13) to enable/disable RMON support
or to attach the Agent Module to either the 10 or 100 Mbps segment. Table 12
describes the RMON configuration parameters.
------------------------------------------------------------
<APPLY>
Use ESC for help. Use arrow keys to move.
<Enter> to confirm.
------------------------------------------------------------
Table 12 RMON Configuration Parameters
Parameters
10M Segment RMON
100M Segment RMON
Full Segment Enable
1
Agent Attached to
1. If no path exists between the two repeater segments via an Internal Switch Module or by other
external network connections, then the SNMP, HTTP and Telnet protocols will only have man-
agement access to the repeater segment attached to the Agent Module.
To use the functions provided by RMON, you must access the hub's agent with
an SNMP management program that supports RMON.
RMON Configuration
10M Segment RMON
100M Segment RMON
Full Segment Enable
Agent Attached to
<OK>
Figure 13 RMON Configuration Screen
Description
Enable/disable RMON support for 10 Mbps segment.
Enable/disable RMON support for 100 Mbps segment.
If RMON is enabled for the segment attached to the Agent
Module, and this option is set to YES, then all 9 RMON
groups are used. If this option is set to NO, only RMON
groups 1, 2, 3 and 9 are used.
Attach the Agent Module to either the 10 or 100 Mbps
segment. Note that only the segment attached to the agent
can provide full RMON support.
Note
: Disable
: Enable
: NO
: 100M
<CANCEL>