Displaying System Information - Allied Telesis AT-FH812u User Manual

Displaying System
Information
Use the System Information screen to display descriptive information about the
hub, or for quick system identification, as shown in Figure 3 and Table 2.
------------------------------------------------------------
System Description
System Object ID
System Up Time
System Name
Contact
Location
<APPLY>
<Ctrl-F> forward a char, <Ctrl-B> backward a char.
------------------------------------------------------------
Pressing the <APPLY> button makes all changes permanent by writing them to
EEPROM.
Pressing <OK> implements all changes temporarily--these changes will be
voided if the system is reset.
Pressing <CANCEL> will drop any changes as long as the <APPLY> or <OK>
buttons have not been pressed, and will exit to the parent menu.
Parameter Description
System Description System hardware description.
System Object ID Object identifier for the hub's network management subsystem as
defined in MIB II.
System Up Time Length of time the current management agent has been running.
(Note that the first value is seconds.)
1
System Name Name assigned to the hub system.
2
Contact Contact person for the system.
3
Location Specifies the area or location where the system resides.
1, 2, 3
: Maximum string length is 255, but the screen only displays 44 characters. You can use the
arrow keys to browse the whole string.
System Information
: CentreCOM FH812U
: 1.3.6.1.4.1.259.5.7
: 134367 (0 day 0 hr 22 min 23 sec)
: dual-speed hub
: system administrator
: headquarters
<OK>
The name of this system.
Figure 3 System Information Screen
Note
Table 2 System Information Parameters
AT-FH812u and AT-FH824u User's Guide
<CANCEL>
7