NEC N8100-1417F User Manual page 83

Option
BMC IRQ
Post Error Pause
AC-LINK
Power ON Delay
Time (Sec)
Platform Event
Filtering
IMPORTANT:
Power Supply), select [Server] - [AC LINK] - [Power On].
The table below shows the operation when the AC power to the server is turn off once and then on
again, depending on the setting of "AC LINK."
System status before AC power off
Operating
Aborting (DC power being off also)
Forced shutdown*
* Press the power switch continuously for four seconds or longer. This forcibly turns off the power.
Parameter
Disabled
[IRQ 11]
Disabled
[Enabled]
Stay Off
[Last State]
Power On
[20] - 255
Disabled
[Enabled]
To power on the server from the UPS (Uninterruptible
Description
Determines routing of the BMC
interrupt.
Specify whether to stop the POST
once at the end of POST if an error
occurs during the POST.
Specify the state of power when the
AC power to the server is turn off
once and then on.
Specify the power on delay time
within the range between 0 and 255
seconds. The time specified is valid
when "Power On" or "Last State" is
specified for AC LINK.
Specify whether to enable or disable
the platform event filtering (PEF)
feature.
Setting of AC LINK
Stay Off Last State
Off On
Off Off
Off Off
Configuring Your Server 4-15
Your Setting
[ ]: Factory-set
Power On
On
On
On