Optional Board Supported By Nec Expressbuilder - NEC N8100-1417F User Manual

Optional Board Supported by NEC EXPRESSBUILDER

NEC EXPRESSBUILDER attached to this computer supports the following optional boards:
NOTE: If you want to install the other boards except ones listed
below by using a driver floppy disk ("OEM-FD for Mass storage
device"), see "Exceptional setup" and "Installing Optional Mass
Storage Driver" of "Parameter File Creator" in Chapter 6.
Controllers supporting installation of OS with Express Setup
– N8103-116 RAID controller (128 MB, RAID0/1)
– N8103-117 RAID controller (128 MB, RAID0/1/5/6)
Other controllers
– N8103-90 Disk Array Controller (External SAS HDD)*
– N8103-75 SCSI Controller*
– N8103-95 SCSI Controller*
– N8103-107 SCSI Controller*
– N8103-104 SAS Controller*
* Option
NOTES:
The driver of option card mentioned above is stored in the
EXPRESSBUILDER DVD.
If you use the board not mentioned above, the ExpressSetup will
fail. Refer to the instructions attached to the board.
About the Hardware Components
When you install the Windows Server 2003, Express Setup requires several preparations if this
computer uses the following hardware components.
Installing on the Mirrored Volume
If you want to install the Windows Server 2003 on the volume that is mirrored using "Disk
Management", invalidate the mirroring and set back to the basic disk before the installation, and
validate the mirroring again after the installation.
You can create, invalidate or delete the mirror volume by using "Disk Management" in "Computer
Management".
Installing the Operating System with Express Setup 5-5