NEC N8100-1417F User Manual page 146

4-78 Configuring Your Server
Disk Array
WebBIOS manages Disk Array by a number beginning with 0. You can see a number of Disk Array
where [DG X] in Physical Drives and Virtual Drives.
Universal RAID Utility manages Disk Array by a number beginning with 1. You can see a number
of Disk Array where [Disk Array] in the property of Logical Drive on RAID Viewer or [RAID
Controller #X Disk Array #Y] in the property of Disk Array on raidcmd command.
Physical Drive and Physical Device
WebBIOS manages Physical Drive by three numbers (Connector number:Enclosure number:Slot
number). You can view these numbers shown by [x:x:x] in Physical Drives box. Note, however, the
Connector number is always shown as "()" because it is not supported with this server. The
Enclosure numbers are represented by a number beginning with 1, and the Slot numbers are
represented by a number beginning with 0.
Universal RAID Utility manages Physical Device by a number beginning with 1 and ID, Enclosure
number, and Slot number. The numbers of physical devices connected to the controller are sorted in
ascending order based on ID and assigned number beginning with 1, starting from the smallest
number. The ID is same value of Connected Port shown in Physical Drives Properties box in
WebBIOS. Enclosure number and Slot number are assigned with a number beginning with 1.
IMPORTANT:
box of WebBIOS are represented by a number beginning with 0, but
those in Universal RAID Utility are represented by a number beginning
with 1.
Setting of Priority
WebBIOS displays and sets Rebuild Priority and Patrol Read Priority, Consistency Check Priority of
RAID Controller by percentage. But, Universal RAID Utility uses three levels as High/Middle/Low
for them.
The setting value of WebBIOS and the display level of Universal RAID Utility
Item
Rebuild Priority
Rebuild Rate (WebBIOS)
Patrol Read Priority
Patrol Read Rate (WebBIOS)
Consistency Check Priority
Consistency Check Rate
(WebBIOS)
Note that the slot numbers shown in Physical Drives
Setting value of WebBIOS
80 to 100
31 to 79
0 to 30
80 to 100
31 to 79
0 to 30
80 to 100
31 to 79
0 to 30
Universal RAID Utility level
High
Middle
Low
High
Middle
Low
High
Middle
Low