NEC N8100-1417F User Manual page 65

To connect the power cord from the server to an interruptive power supply (UPS), use service
outlets on the rear of the UPS.
To connect the power cord from the server to an interruptive power supply (UPS), use service
outlets on the rear of the UPS.
Refer to the manual that comes with the UPS for details.
When the power cord from the server is connected to a UPS, change the BIOS SETUP utility of the
server to link with power supply from the UPS.
Change a parameter for "AC-LINK" of the Server menu of the BIOS SETUP utility. See Chapter 4
for details.
Setting Up Your Server 3-9
Connect the battery connector when
using UPS.
Disconnect the connector when
moving the UPS to relocate it.