Table of Contents
Advertisement
PREPARING FOR INSTALLATION AND REMOVAL
Prepare the installation or removal of a component depending on the following procedure:
1.
Shut down the OS.
2.
Press the POWER switch to turn off the power of the server. (The POWER/SLEEP lamp
goes off.)
3.
Pull out all the power cords from the AC inlet on the server.
4.
Remove all the cables connected to the server on the rear panel.
5.
Make the clearance of 1 m to 2 m in the front and rear sides and left and right sides of the
server.
Upgrading Your Server 9-5
Advertisement
Table of Contents
Troubleshooting
