Secure The Floppy Disk Drive To The Server Chassis With Two Screws That Come With The; Close The Front Mask; Fold The Four Stabilizers At The Bottom Of The Server Toward Inside; Lay The Server Slowly And Gently So That Its Right Side Faces The Floor - NEC N8100-1417F User Manual

7.

Secure the floppy disk drive to the server chassis with two screws that come with the

drive.
8.

Close the front mask.

9.

Fold the four stabilizers at the bottom of the server toward inside.

10.

Lay the server slowly and gently so that its right side faces the floor.

11.
Route the 10-pin connector side of USB interface cable through the space between the fan
and the bottom face and around the mother board.
NOTE:
If any other USB device than the internal USB floppy disk
drive has been installed in the server, use the interface cable for internal
USB floppy disk drive stored in the chassis. Do not use an interface
cable that comes with the floppy disk drive.
Upgrading Your Server 9-65