NEC N8100-1417F User Manual page 270

9-12 Upgrading Your Server
Installation
Install a hard disk drive in the following procedure. A hard disk drive may be installed in any other
slot in the similar procedure.
IMPORTANT:
Fill the bays bottom-to-top.
Hard disk drives are connected with the Internal RAID Controller
(equivalent to N8103-116).
In RAID system, hard disk drives should have the same
specification including the capacity.
NOTE:
only by opening the front door. In the RAID system, hard disk drives
may be installed or removed with the power of the server being on.
1.
Release the lock of the front door by using the security key to open the front door.
2.
Locate the slot in which the hard disk drive is installed.
There are four slots. The port numbers are defined depending on the locations of the slots
(PORT0 to PORT3 from bottom to top).
3.
Hold the handle of the dummy tray and remove the dummy tray.
IMPORTANT:
Keep the dummy tray carefully.
The purpose of a dummy tray is to increase the cooling effect in the
server. Install a dummy tray in slots not containing a hard disk
drive.
Hard disk drives can be installed or removed from the server