Default Settings; Table 2.1:Pci-1601/1602/1611/1612/1622 Default Set Ting; Figure 2.20:Pci-1603 Default Setting - Advantech PCI-COMM Series User Manual

2.3.2 Default Settings

The board is shipped with default settings. If you need to change these
settings, however, see the following sections. Otherwise, you can simply
install the card.
PCI-1601/1602/1611/1612/1622.
Table 2.1: PCI-1601/1602/1611/1612/1622 Default Setting
RS-422/485 Mode
Enable Mode
PCI-1603
The board will be shipped in the RS-232 mode, passive Rx and active Tx.
On the 10*2 pin jumper groups (JP2 & JP4)— A, B, C, D and E are set to
RS-232 transmission mode. On the 6*2 pin jumper groups (JP3 & JP5)—
C, D and E are set to passive Rx and active Tx. They are the card default
settings.
JP2 & JP4
JP3 & JP5
PCI-COMMUNICATION User Manual 30
RS-422
Auto
A B C
A
Figure 2.20: PCI-1603 Default Setting
D E F G
B C D E
H I J
F