Advantech PCI-COMM Series User Manual page 8

2.4
Chapter 3 Driver Setup & Installation.......................... 38
3.1
3.2
3.3
3.4
3.5
3.6
3.7
Chapter 4 ICOM Tools ................................................... 60
4.1
4.2
4.3
4.4
4.5
Chapter 5 Pin Assignments and Wiring........................ 74
PCI-COMMUNICATION User Manual viii
Figure 2.26:Passive Mode Jumper Setting .................. 33
Figure 2.27:Resistor Selection ..................................... 34
Card Installation .............................................................. 35
Introduction ..................................................................... 38
Driver Setup .................................................................... 38
3.2.1 Steps for Windows 98/2000/XP Driver Setup ............. 38
Reboot System after Win98/2000/XP Driver Setup ....... 44
3.3.1 PCI UARTs Device Driver Installation ....................... 44
3.3.2 PCI Bridge Device Driver Installation ......................... 46
Verify your Win98/2000/XP Driver Setup ..................... 47
Configuring Serial Devices for Win 98/2000/XP ........... 50
3.5.1 Configuring a PCI UARTs Device .............................. 52
3.5.2 Configuring a PCI Bridge Device ................................ 53
3.5.3 Configuring Ports ......................................................... 53
Remove PCI ICOM Series Device.................................. 54
Driver Uninstall............................................................... 57
Introduction .................................................................... 60
Installation....................................................................... 60
User Interface of ICOM Tools ........................................ 61
4.3.1 Menu Bar ..................................................................... 61
4.3.2 Tool Bar ....................................................................... 62
4.3.3 Com Port Tab ............................................................... 63
4.3.4 Port Status .................................................................... 64
4.3.5 Message Logo .............................................................. 64
4.3.6 Tx Slide Bar ................................................................. 65
4.3.7 Performance Listing Area ............................................ 65
4.3.8 Status Bar ..................................................................... 65
Using the ICOM Tools Utility ........................................ 66
4.4.1 Port Selection ............................................................... 66
Figure 4.1:ICOM Tools program window ................... 66
Figure 4.2:Select Port dialog box ................................ 67
Figure 4.3:Ports You Select Will Appear in the Selected
Port Checkbox Group 67
Figure 4.4:ICOM Tools User Interface ........................ 68
4.4.2 Configuring a Port ....................................................... 68
Figure 4.5:Test Information on the Performance Listing
Area 69
4.4.3 Close Port ..................................................................... 70
4.4.4 Exit the ICOM Tools utility ......................................... 70
Messages on Status Bar and Message Logo Area........... 71
4.5.1 Status Bar Messages .................................................... 71
4.5.2 Message Logo Messages ............................................. 72