3.2
Connector and Jumper Locations & Settings
Table 3.1: PCIE-1680 Board Silk Screen
Item
CN2, CN3
JP1, JP2
3.2.1
How to Set Jumpers
You configure your card to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch. It consists of two metal pins and a small
metal clip (often protected by a plastic cover) that slides over the pins to connect
them. To "close" a jumper you connect the pins with the clip. To "open" a jumper you
remove the clip.
Figure 3.1 PCIE-1680 CAN-bus board silk screen
Description
DB-9 Male Connector
Terminating Resistor Jumper
Figure 3.2 How to set jumpers
13
PCIE-1680 User Manual