Simplified Audio Schematic; User Manual Cu 6105.Docx - Danish Interpretation Systems DCS 6000 User Manual

DIS
2. Chain outputs – Two RJ45 connectors for
connecting Conference Unit. The connection and
protocol is called DCS-LAN.
Important: The 'Chain' outputs are only for connecting
Conference Units or other DCS-LAN compatible
equipment.
Connecting a LAN (TCP/IP) connection from a third
part device to this output may damage both the third
part device and the CU 6105.
3. LAN (TCP/IP) connector – A RJ45 connector for
connection to local area network (LAN). This
connector is used to connection to the built in
web application or for connection to SW 6000 or
a control system like AMX® or Crestron®.
4. Audio output A, B, C & D – Four male XLR3
connectors for connection of PA systems, Audio
Mixers, Audio
Distribution System etc.
6.2

Simplified Audio Schematic

Recorders or Language
Figure 6.2-A

User Manual CU 6105.docx

5. Audio input In 1 & In 2 – Two female XLR3
connectors for extra audio inputs. 'In 1' and 'In 2'
is used to connect auxiliary symmetrical audio
signals such as a wireless microphone to the floor
language.
'In 2' is also used for connection of an 'Emergency
Evacuation Message (EEM)' audio signal.
6. Emergency switch connector – A terminal block
socket for a single, 'normally open' switch. When
the switch is closed, the audio signal on the 'In 2'
connector is distributed on all output channels
and loudspeakers, overriding all other audio
inputs.
Note: There is no volume control available for setting the
EEM volume on 'In 2'. The volume has to be set at the
equipment generating the "Emergency Evacuation Message
(EEM)" audio signal.
CU 6105 Central Unit Audio Schematic
User Manual
17