Getting Started; Setting Up The System The First Time; Connecting A Pc - Danish Interpretation Systems DCS 6000 User Manual

DIS
4

Getting Started

4.1

Setting up the system the first time

When setting up the system for the first time please
follow the instruction given in this section in
sequence.
1. Unpack the CU 6105 Central Unit and connect
the power cord to the CU Power Supply and
connect the cable from the power supply to the
CU 6105.
Please refer to section '6 CU 6105 Central Unit'
for details.
2. Place all units at the positions, where they are
to be used observing the unit type.
3. Connect the GM Gooseneck Microphone to the
units. If needed fix the gooseneck microphones
to the units with the tool delivered with the CU
6105.
4. Connect the units to one or two of the DCS-LAN
connectors on the CU 6105 using EC 6001-xx
Cat5e extension cables in suitable length
observing that the cables are not bended to a
radius less than 15 mm.
4.2

Connecting a PC

When connecting a PC direct to the CU 6105 please
follow the instruction given in this section in
sequence.
1. Connect the PC and the CU 6105 with a
standard LAN cable
2. Turn 'On' power to both units
3. On the PC check that the network setting is set
to 'Obtain an IP address automatically':
a. Navigate to 'Control Panel * Network and
Sharing Center * Change adapter settings *
Local Area Connection'.
b. Select 'Properties'
c. Select 'Internet
(TCP/IPv4)
Protocol Version 4
User Manual CU 6105.docx
Please refer to section '5 General Guidelines'
for details
5. Connect power to the CU Power Supply. The
light indication in the power switch on the CU
6105 will light red.
6. Activate the power switch on the CU 6105 and
the light indication in the button will light
green. After about 15 seconds, the display in
the CU will be visible and the LED's in the
conference units will flash until the units are
registered (less than 60 seconds).
7. Check that the units are working by activation
the 'Speak' button.
8. Adjust the 'Loudspeaker volume' to a desired
level using the interactive menu on the front of
the CU 6105.
Please refer to the section '6.4 Using the
Interactive Menu ' for details.
d. Click 'Properties'
e. Change setting to 'Obtain an IP address
automatically'
4. Using the interactive menu on the CU 6105
navigate to:
a. 'LAN setup * Acquire IP addr.'
b. Select 'Dynamic'.
5. Using the interactive menu on the CU 6105
navigate to:
a. LAN setup * IP address setup * IP address *
Actual IP address
b. Note the IP address
6. Open the internet browser in the PC
User Manual CU 6105
11