6.3.11 Connecting An Emergency Signal; Using The Interactive Menu; Overview; Navigate Through The Menu - Danish Interpretation Systems DCS 6000 User Manual

DIS
Figure 6.3-M DCS 6000 Digital Conference System with advanced SW 6000 setup

6.3.11 Connecting an emergency signal

To use the emergency signal function, a switch
(normally-open) must be connected to the emergency
switch connector. When the switch is closed an
"Emergency Evacuation Message (EEM)" audio signal
6.4

Using the Interactive Menu

The major configurations and operation options of 6.4.1

Overview

the CU 6105 can be set via an interactive menu, using
the 2x20 character OLED display and the 5-button
keypad.
'Figure 5.3 A' gives an overview of the menu
structure, however for a general description of the
settings in the menu refer to the section '6.5 Web
Browser', where all CU 6105 settings are explained.
present on the 'In 2' input is distributed to all output
channels, overriding all other audio inputs.
Important: The level of the signal must be controlled
externally.
Figure 6.4-A
Navigation in the menu and changing parameters is 6.4.2
done by activation the 5-button keypad:


User Manual CU 6105.docx

Menu overview

Navigate through the menu

Cycle through the menu items (Blue marking)
with the four 'arrow' buttons (Left-Right, Up-
Down).
User Manual
27