Control - Danish Interpretation Systems DCS 6000 User Manual

DIS
<level> The level of line input 1 ranges from -41 to 0. The value -41 indicates Off, whereas values from -40 to 0
indicates attenuation in dB.
The CU responds to this command by returning a 'line_input_level_1' command.
10.3.1.3 Set line output volume (A-D)
Adjust the level of line output signal.
line_output_volume <output> <volume><CR>
<output> Indicates which output is being controlled. Possible values: 'A', 'B', 'C', 'D'.
<volume> The volume of line output ranges from -41 to 0. The value -41 indicates Off, whereas values from -40 to 0
indicates attenuation in dB.
The CU responds to this command by returning a 'line_output_volume' command.
10.3.1.4 Define audio path
This command defines audio connections in the system.
audio_path <path> <on/off><CR>
<path> Indicates which connection is being controlled. Possible values: 'mic_to_speaker', 'mic_to_floor',
'linein_1_to_speaker', 'linein_1_to_lineout_A', 'linein_1_to_floor'.
<on/off> Indicates, whether the audio is being routed from microphones/lineinput_1 to speakers/lineoutput/floor.
The CU responds to this command by returning an 'audio_path' command.
10.3.1.5 Request audio status
System audio status.
audio_status<CR>
The CU responds to this command by returning a list of commands for the Audio settings:
line_output_volume (for all outputs A-D)
loudspeaker_volume
audio_path (for all paths)
line_input_level
audio_status_done
10.3.2 Commands from CU 6105 to External Control
10.3.2.1 Loudspeaker volume
Volume of loudspeakers for all Conference units.
loudspeaker_volume <volume><CR>
User Manual CU 6105.docx
User Manual
63