Firmware Update; User Manual Cu 6105.Docx - Danish Interpretation Systems DCS 6000 User Manual

DIS
A microphone cannot be turned 'On'
The CU 6105 browser application will
not open in a PC or iPad
The CU 6105 browser application will
not open in iPad
The Interpreter Units does not work
8

Firmware Update

If firmware update of the CU 6105 Central Unit is needed for maintenance, this is done using the browser interface.
Type the 'IP address' or 'Host Name' followed by '/cgi-bin/update.cgi' into the browser as shown in Figure 6.7-A.
The CU 6105 Update window is then shown:
Copy the update file to the PC and locate the file using the 'Browse' button. The update file has the format
'cu_6105_xxxxxx.dis'. If maintenance update is needed the update file is delivered from your support source.
After selecting the update file click the 'Go' button and the update process is started:
50
Check the settings 'Max Delegate Speaker' and 'Max Total
Speakers'.

Check the 'Operation Mode'.
Check the IP address using the interactive menu on the CU: 'LAN

setup/IP address setup/IP address'. Use this IP address in the

browser
Check that the CU 6105 is connected to the same network as the
PC

Check the LAN cables
Check the IP address using the interactive menu on the CU: 'LAN

setup * IP address setup * IP address'. Use this IP address in the

browser.
Check that the iPad is connected to the correct wireless access
point

Check that the CU 6105 is connected to the same network as the
wireless access point

The channel setup on each interpreter unit is not setup. Use a
combination of b-B buttons to configure. For detail please consult

the 'User Manual IS 6132 P'
Figure 6.7-A Browsing for update file

User Manual CU 6105.docx

User Manual