Cleaning The Paper Feed Roller - Canon MG8100 series On-Screen Manual

> Routine Maintenance
Contents
C099

Cleaning the Paper Feed Roller

If the Paper Feed Roller is dirty or paper powder is attached to it, paper may not be fed properly.
In this case, clean the Paper Feed Roller. Cleaning will wear out the Paper Feed Roller, so perform this
only when necessary.
You need to prepare: three sheets of A4 or Letter-sized plain paper
1.
Make sure that the power is turned on.
2.
Open the Paper Output Tray gently, and open the Output Tray Extension.
Important
If the Inner Cover is open, close it.
3.
Select Roller cleaning.
Select Setup
(1)
See Selecting Menus on the HOME Screen
The Setup menu screen will appear.
Select Maintenance
(2)
The Maintenance screen will appear.
Select Roller cleaning, and touch the
(3)
The confirmation screen will appear.
Select Yes, and touch the
(4)
Select the paper source to clean (Rear tray or Cassette), and touch the OK
(5)
button.
4.
Clean the Paper Feed Roller without paper.
Follow the message to remove paper in the paper source you selected in (5) of
(1)
step 3.
Touch the button.
(2) OK
The Paper Feed Roller will rotate as it is cleaned.
5.
Clean the Paper Feed Roller with paper.
Make sure that the Paper Feed Roller has stopped rotating, then follow the
(1)
message to load three or more sheets of A4 or Letter-sized plain paper in the
paper source you selected in (5) of step 3.
Touch the button.
(2) OK
The machine starts cleaning. The cleaning will be completed after the paper is ejected.
> Cleaning the Paper Feed Roller
on the HOME screen.
.
, and touch the
OK
OK
button.
OK
Advanced Guide
button.
button.
Troubleshooting