Device User Settings; Bluetooth Settings; Pictbridge Print Settings; Language Selection - Canon MG8100 series On-Screen Manual

Device user settings

Date display format
Selects the format of date that is displayed on the LCD or printed on papers.
Read/write attribute
Selects whether to use the Card Slot of the machine as the memory card drive of a computer.
Volume control
Adjusts the keypad volume generated when touching the buttons on the Operation Panel, or the
alarm volume generated when there is a conflict in the settings or an error.
Power save setting
Selects the length of wait time until the machine enters the Power save mode.
The machine enters the Power save mode if not operated for a certain time interval. In the Power
save mode, the FAU (Film Adapter Unit) lamp will be turned off to reduce the power consumption of
the machine.
The default setting is 15 minutes.
Quiet mode setting
Enables this function if you want to reduce the operating noise of the machine, such as when using
the machine at night (when copying, printing from the memory card, printing from the PictBridge
compliant device, printing with wireless communication, etc.).
Guide display settings
The guidance appears at the top of the operation screen or settings screen. You can change the
time interval before the guidance appears or hide it.
Key repeat
Enables to increase or decrease numbers rapidly by holding your finger on a button when inputting
numbers. When this setting is disabled, holding your finger on the button is the same as touching it
once.
Mobile phone print settings
Specifies paper or image correction when you print from the wireless communication device.

Bluetooth settings

Changes the Bluetooth settings, such as the device name or passkey. This setting appears only
when the optional Bluetooth Unit is connected to the machine.

PictBridge print settings

Specifies paper, print quality, etc. when you print from the PictBridge compliant device.

Language selection

Changes the language for LCD messages and menus.

Reset setting

Sets the machine settings back to the default. (However, the settings configured in LAN settings, the
values set for the print head alignment, the setting in Read/write attribute, and the language set in
Language selection will not be reset.)