Canon MG8100 series On-Screen Manual page 51

>
Contents Reprinting Photos from Printed Photos
C154
Removing the Films
Remove the films from the Film Guide, and store the Film Guide onto the Document Cover again.
1.
Open the Document Cover to remove the Film Guide.
2.
Remove the film strip or mount films from the Film Guide.
For the mount films:
After the mount films are removed, reassemble the Film Strip Frame with the Film Guide.
Align the alignment marks
(1)
on the Film Guide, and insert the tabs on the leading edge of the Film Strip
Frame into the Film Guide.
Push down to close the Film Holder completely.
(2)
Note
If the Film Holder does not close completely, push the whole Film Holder gently downward
to fit the protrusions in the slots of the Film Guide.
3.
Reattach the Film Guide.
(1) Reattach the Film Guide behind the FAU Protective Sheet.
Turn over the Film Guide, then insert it at an angle all the way into the fittings (A) of the FAU Protective
Sheet.
Reattach the FAU Protective Sheet with the Film Guide to the Document Cover.
(2)
Insert the protrusions of the FAU Protective Sheet into the slots of the Document Cover, and press both
sides at top of the FAU Protective Sheet to fit it in.
Advanced Guide
> > Removing the Films
Loading the Films
on the Film Strip Frame with the alignment marks
Troubleshooting