Print Head Holder Does Not Move To The Position For Replacing - Canon MG8100 series On-Screen Manual

Advanced Guide >
Troubleshooting
U325

Print Head Holder Does Not Move to the Position for Replacing

Check 1: Is the POWER lamp off?
Check if the POWER lamp is lit blue.
The Print Head Holder will not move unless the power is on. If the
Scanning Unit (Cover) and turn the machine on.
While the POWER lamp is flashing blue, the machine is initializing. Wait until the
stops flashing and remains lit blue, and then open the Scanning Unit (Cover) again.
Check 2: Is an error message displayed on the LCD?
Close the Scanning Unit (Cover), follow the directions displayed in the error message to resolve the
error, and then reopen it. For details on how to resolve the error, see
.
on the LCD
Check 3: Has the Scanning Unit (Cover) been left open for 10 minutes or
longer?
If the Scanning Unit (Cover) is left open for more than 10 minutes, the Print Head Holder moves to
the right to prevent the Print Head from drying out. Close and reopen the Scanning Unit (Cover) to
return the Print Head Holder to the position for replacing.
Check 4: Has the machine been printing continuously for a long
period?
Close the Scanning Unit (Cover), wait a while, then reopen it.
If the machine has been printing continuously for a long time, the Print Head Holder may not move to
the position for replacing since the Print Head may overheat.
Note
Opening the Scanning Unit (Cover) while printing moves the Print Head Holder to the right. Close
the Scanning Unit (Cover), and reopen it after printing finishes.
> Print Head Holder Does Not Move to the Position for Replacing
POWER lamp is off, close the
POWER lamp
An Error Message Is Displayed
Page top