Cleaning The Paper Feed Roller - Canon Pixma MG3550 Online Manual

Cleaning the Paper Feed Roller

If the paper feed roller is dirty or paper powder is attached to it, paper may not be fed properly.
In this case, clean the paper feed roller. Cleaning will wear out the paper feed roller, so perform this only when necessary.
You need to prepare: a sheet of A4 or Letter-sized plain paper or commercially available
cleaning sheet
1. Make sure that the power is turned on and remove any paper from the front tray.
2. Clean the paper feed roller without paper.
(1) Hold down the Stop button until the Alarm lamp flashes orange seven times, then release it
immediately.
The paper feed roller will rotate as it is cleaned.
3. Clean the paper feed roller with paper.
(1) Make sure that the paper feed roller has stopped rotating, load a sheet of A4 or Letter-sized
plain paper or commercially available cleaning sheet in the front tray.
(2) Open the output tray extension, open the paper output tray, then extend the paper output
support.
(3) Hold down the Stop button until the Alarm lamp flashes orange seven times, then release it
immediately.
The machine starts cleaning. The cleaning will be complete when the paper is ejected.
If the problem is not resolved after cleaning the paper feed roller, contact the service center.
121