Troubleshooting; Printing A Test Label - Avery Dennison MonarchNet2 9855 Operating Insructions

T R O U B L E S H O O T I N G
This chapter contains information about printing a test label and
correcting some problems that may occur.
P r i n t i n g a T e s t L a b e l
If you have difficulty communicating with the print server or printer:
Verify that the printer is operating properly, is online, and supplies
1.
are loaded correctly.
If the printer is working correctly, test the connection between the
2.
printer and the print server by pushing the test button on the back of
the printer for less than five seconds. A sample configuration label
should print. See Chapter 1, "Getting Started" for more information.
Press and hold
3.
A series of test labels print. The third test label contains wireless
and network settings. If the test labels do not print, call Service.
IP Address
Boot Tries
SSID
W E P
The third test label displays the settings for the IP address,
subnet address, IP gateway, boot tries, boot method, SSID,
wireless mode, WiFi WEP, WiFi signal, packets received, bad
packets received, and packet collisions. It also lists Smart Relay
information. See Chapter 2 or 3 if you need to change any of the
IP or wireless settings.
and at the same time one second and release.
Netw ork/Wireless Test Label
6
Boot Method
Wireless Mode
Signal Strength

Troubleshooting 6-1