Avery Dennison MonarchNet2 9855 Operating Insructions page 49

Set the Regulatory Domain, which is the country of use.
8.
Set the AP Density: Low, Medium, or High. If the communication
9.
quality (transmit rate) between devices on a network drops below a
certain level, the devices scan for another access point in the area
offering better transmit rates, etc.
10. Set the Encryption Mode: Disable, 64 BIT Encryption, 128 BIT
Encryption, WPA, WPA2, WPA2-WPA. WPA2-WPA works as either
WPA2 or WPA. The encryption mode determines the algorithm used
to encrypt messages.
11. Set the Authentication Type: Open, Shared, TLS, TTLS, LEAP,
PEAP, EAP-FAST, or PSK. The authentication type specifies how
users are identified and verified on a network. These options vary
depending on what was selected as the Encryption Mode.
See "Basic Security Configurations" for more information.
12. Enable WPA Group Key to use a group key for data link encryption.
13. Enter the maximum number of Authentication Attempts.
14. Enter the Pre-shared key, which must be exactly 64 hex characters.
If using a pass-phrase, it must be 8 to 63 displayable characters.
15. Set the Authentication Protocol: PAP, or MSCHAP_V2.
See "Basic Security Configurations" for more information.
16. Enter the User ID.
17. Enter the Password.
18. Click Submit when you are finished.
19. Click the Protocols tab.
20. Click Save Re-init Network (on the Protocols tab) before any
changes take effect. Even though you submitted your changes on
the previous screen, they do not take effect until you click Save Re-
init Network. This process takes a few minutes.
Using a Web Browser 3-15