Avery Dennison MonarchNet2 9855 Operating Insructions page 77

SET EN CERTKEY <keyvalue>
Sets the EAP root key value.
SET EN CHannel nn
Sets 802.11b/g wireless channel.
SET EN ENC [DISable/64/128/WPA/WPA2/WPA2-WPA/
Dynamic WEP]
Sets the encryption mode. See Chapter 3, "Using the Web Interface" for more
information.
SET EN ID <userID>
Sets the authentication user ID. It may include the realm, separated with the
"at" ("@") character.
SET EN INAP [PAP/MSCHAP_V2]
Sets the EAP inner authentication protocol.
SET EN IROAM [DISable/STRICT/FLEXible]
Controls whether the radio frequencies are set based on the radio configuration
or from its access point. Disabled uses the radio defaults. When in Ad-Hoc
mode, you must set the region of operation. See "SET EN REGDOMain".
Flexible uses access point settings if present, otherwise the radio defaults are
used. When in Ad-Hoc mode, you must set the region of operation. See "SET
EN REGDOMain". Strict uses access point regulatory frequency information.
When using an access point, there is no need to set the region of operation.
SET EN PW <password>
Sets the password for 802.11b/g EAP authentication.
SET EN KEY# <1/2/3/4>
Sets which WEP key number to use (default is 1).
SET EN KEYVAL <WEPkey>
Sets WEP key value. Must be hexadecimal.
SET EN MODE [IN/AD]
Sets 802.11b/g wireless mode to infrastructure or Ad-Hoc mode.
SET EN REALM <realm>
Sets the realm portion of the 802.11b/g EAP authentication ID.
Console Commands 4-17