Clean The Reinforcement Knives - Oce TDS860 User Manual

Clear the box.
2
Push the waste box forward and push it to the right hand side to close the waste
3
box (see figure 161).
[161] Close the waste box

Clean the reinforcement knives

The knives of the reinforcement unit get sticky from the glue on the
reinforcement tape. Clean the knives when you insert a new tape roll (see 'A
new tape roll' on page 252) or when an error in the Reinforcement Unit
occurred.
Put the knives into a position so that you have access to all parts.
Attention:
Cleaner K and Fixing Unit Cleaning Oil (silicon oil) from Océ.
How to clean the reinforcement knives
Press the on-line key on the printer operator panel to put the printer off-line.
1
The message 'Off line' is displayed in the status window.
Press the left selection key to shift the focus to 'Clean reinf. knife'. A shadow
2
effect is used to indicate that the focus is set to this menu.
Select the right selection key 'Clean'. The reinforcement knives are placed in
3
the correct position.
The machine stops and the yellow indicator on the printer goes ON.
4
A picture of the printer appears on the display with the side door of the
5
reinforcement unit flashes.
To see the text, press the 'text' key.
6
When a job is running, the message 'Job interrupted' appears. The
Note:
machine stops running after it has correctly finished the prints that were
already in the printer.
Maintenance
To avoid damage to the Reinforcement Unit, only use the original
261