Oce TDS860 User Manual page 228

Set the folded package length)
Press the 'Finishing' card in the 'Print' section.
1
Press the function key 'Folded package'.
2
Select 'Length'.
3
Enter a range between 276 - 310 mm or 10.9 - 12.2 inch., in steps of 1 mm or
4
0.1 inch; default 297 mm or 12 inch
Set the binding strip
Press the 'Finishing' card in the 'Print' section.
1
Press the function key 'Binding'.
2
Select binding enabled or disabled.
3
If you selected enabled enter a range between 15 - 30 mm or 0.6 - 1.2 inch, in
4
steps of 1 mm or 0.1 inch; default 20 mm or 0.8 inch.
Set the reinforcement
Press the 'Finishing' card in the 'Print' section.
1
Press the function key 'Binding'.
2
Select 'Reinforce' enabled or disabled.
3
Reinforcement is only possible with the Standard folding method
Note:
You can overrule the standard folding program with settings from the printer
driver or the scanner operator panel.
Find more information about Océ printer drivers in the on-line help. How to
make folding settings on the Scanner panel is described below.
See 'Standard folding settings' on page 227 for complete information about
defining default folding settings.
Fold settings from the scanner operator panel
Open the 'Feeding' card in the 'Original' section and press the 'Legend
1
location' function key to select the required legend location ('Leading' or
'Trailing').
Make certain that your legend is always located on your left-hand
Note:
side to ensure correct positioning of the legend during folding.
Press the 'Drawing method' function key to select 'Standard', 'Ericsson' or
2
'Afnor' fold.
228 Océ TDS860 User Manual