Job Templates - Oce TDS860 User Manual

Job templates

A job template contains direct access to five settings for fast selection or
verification. It also contains the default settings for a certain job. Figure 30 on
page 80 shows an example with the following job templates.
Template 1
Template 2
Template 3
Template 4
Last used
The key operator defines the settings in the Océ Settings Editor on the Océ
Power Logic controller (see 'Define the job templates' on page 185). The key
operator can change the job template names, except for 'Last used', for
example into the following job template names.
Single copy
Set copy
Matrix copy
Scan-to-file
Last used
When you select the 'Last used' job template, you recall all settings from the
previous job. You can change the settings or do the same job again. The 'Last
used' job template does not display when you turn on the scanner.
After you select a template, the sections display. The sections provide access
to the settings for the scanner input, the printer output and the scan-to-file
output (see 'Sections on the operator panel' on page 80). Use the Custom Card
here to provide access to frequently used settings referred to the type of job.
Using the Océ TDS600 scanner to copy 83