Table of Contents
Advertisement
Positioning the reinforcement knives (optional)
Because the knives of the optional reinforcement unit of the folder get sticky
from the glue on the reinforcement tape, they have to be cleaned regularly. You
are recommended to clean the knives each time you have inserted a new tape
roll (see 'A new tape roll' on page 232) or when an error in the reinforcement
unit has occurred.
Before you can clean the reinforcement knives, you have to place them in such
a position that all the parts that need to be cleaned are accessible. You can do
this from the printer operating panel.
Prepare the reinforcement knives for cleaning
Press the on line button on the printer operating panel to put the printer off line.
1
The 'Off line' message is displayed in the status window.
Press the left selection button to shift the focus to the Folding menu.
2
A shadow effect is used to indicate that the focus is set to this menu.
Select the Special option from the Folding menu.
3
Press the 'start' right selection button to activate the Knife option.
4
The following information is now displayed in the panel display:
[11] Cleaning the reinforcement knife
When a job is running, the 'Job interrupted' message appears. The
Note:
machine stops running after it has correctly finished the prints that were
already in the engine. Then the reinforcement knives are placed in the
correct position.
You can now continue to clean the reinforcement knives (see 'Maintenance of
5
the reinforcement knives' on page 241).
Using the Océ 9600 Printer
37
Advertisement
Table of Contents
