Define Settings For The Next Original - Oce TDS860 User Manual

Define settings for the next original

You can define the settings for each original you want to copy. When
'Automatic feed' is enabled, you should bear in mind that the original is
automatically pulled into the scanner. If you want to be absolutely sure about
the settings that belong to an original, insert an original when the settings are
correct.
To increase your versatility at the scanner input side, you can ask your
Note:
key operator to turn off Automatic feed. When using the scanner with
automatic feed off, you must press the start key for each new original to be
scanned. This offers you the possibility to change the settings for the next
original, even if you already put the original in place on the scanner feed table.
Define settings for the next copy job
Select all settings required for the next original.
1
Insert the next original.
2
If 'Automatic feed' is off, press the start key.
If 'Automatic feed' is on, the original is fed automatically.
You can enable or disable this function from the 'Scanner' card in the
Note:
'Original' section. See figure 34 on page 87.
94 Océ TDS860 User Manual