Oce TDS860 User Manual page 85

The Correction key
Press the Correction key one time to return to the default value of the active
1
setting.
Press the Correction key two times to set the numeric display to 1.
2
Press the Correction key three times to return to the top layer of the Scanner
3
Operator Panel. When job templates are enabled in the Océ Settings Editor, the
top layer shows the job templates. When job templates are not enabled in the
Océ Settings Editor, the top layer shows the 'Custom' section.
When 'Automatic feed' is selected for a single sheet job, this setting stays
active after the job is completed.
Job interrupt only stays active for one job. You have to press the Job interrupt
key before each new job you want to give interrupt priority.
The Scanner Operator Panel will automatically return to the top layer and the
default settings after the time defined in the 'Panel Time-out' setting in the Océ
Settings Editor (see 'Find system settings in the Settings Editor' on page 187).
Using the Océ TDS600 scanner to copy
use the Correction key to do the following:
85