Basic Operation; Turning Power On; Volume; Channel - Icom IC-440N Instruction Manual

3

BASIC OPERATION

■

Turning power ON

q
Hold down
w
If the transceiver is programmed with a start-up password,
this needs to be entered before the transceiver can be op-
erated.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block, as identical.
Therefore "01234" and "56789" are the same.
[PWR]
F MONI
SET T SQL
PRIO
SCAN SET P
TAG
LOW
O G P
RS
CH
SQL
e
When the "PASWD" indication does not clear after input-
ting 4 digits, the input number may be incorrect. Turn OFF
the power and start over from step q.
If the input number is not as you disired, also start over
from step q.
14
for 2 seconds to turn ON the power.
SCAN
TAG
PRIO
SET P
SCAN O G P PRIO
KEY
O G P
SET P
TAG RS
RS
0 1
LOW
NUMBER
5 6
■

Volume

➥ Push
• " " appears when volume level 0 is selected (while the internal
speaker is muted).
■

Channel

➥ Push
or
LOW
• Holding down
2 3 4
tinuously until channel 1 is selected.
7 8 9
• When channel 1 is selected, beeps sound.
• 'CB-XX' appears when the CB channel is selected, and 'RPT-XX'
appears when the RX channel is selected.
• "
or to select the desired volume level.
CH
to enter the channel selection mode, then push
SQL
to select the desired channel.
or , the displayed channel changes con-
" appears when you select the channel selection mode.
Appears