Rx Frequency (For Rx Channels Only); Rx Channel Setting - Icom IC-440N Instruction Manual

■
RX frequency
The receive frequency in the RX channels can be re-pro-
grammed between 450 to 520 MHz, depending on the set-
ting.
D

RX channel setting

The RX channels do not appear on the LCD (default; "Inhibit"
setting) and cannot be selected. Therefore, the RX channels
should be set to "Enable" before programming the RX fre-
quency.
q
SCAN
While holding down * and
TAG
to display all pre-programmed RX channels (including the
inhibited channels.)
w
Select the desired channel with
SCAN
* to set the displayed channel "Enable."
TAG
"Inhibit" setting
e Turn the power OFF, then ON.
• The "Enable" channels appear on the LCD, and push
push or to select the desired RX channel.
(for RX channels only)
LOW *, turn ON the power
or , and then push
"Enable" setting
CH
, then
SQL
D
RX frequency programming
q
Select the desired RX channel ('RX-XX'). (See to the left)
w
F
Push (Function) to enter the Function mode, then hold
SET
down (RX VFO) for 2 seconds to enter the RX VFO
F
SET
mode.
RX channel
(in Function mode)
e Push
or several times to select the desired fre-
quency.
*Regardless of the assigned key function.
☞
OTHER FUNCTIONS
Appears when
channel spacing
is set.
RX VFO mode
Continued on the next page.
9
9
41