Receiving And Transmitting; Zone Type Selection - Icom IC-440N Instruction Manual

D

Zone type selection

(Available only when more than two zones are set.)
q F
Push (Function) to enter the Function mode, and hold
SET
down (Zone) for 2 seconds to enter the zone select
LOW
mode.
w
Push or to select the desired zone, then push
again to set it.
(Zone)
NOTE:
• 'CB-05,' 'RPT-05' and 'CB-35' channels are used for
emergency.
• No voice transmissions are permitted on 'CB-22' and
'CB-23' (voice operation is inhibited on these channels.)
■

Receiving and transmitting

Receiving:
q
Hold down for 2 seconds to turn ON the power.
• If "T SQL" appears on the display, hold down
onds once or twice to cancel the tone squelch or pocket beep.
(pp. 34, 35)
w
Select the desired operating channel (p. 14).
• When receiving a signal, " " appears and audio is heard from
the speaker.
• Further adjustment of volume level may be necessary at this
LOW
point. (p. 7)
MONI
• Push to toggle the Monitor function ON or OFF.
T SQL
[PWR]
BASIC OPERATION
MONI
for 2 sec-
T SQL
F MONI MONI
SET T SQL
T SQL
PRIO
SCAN SET P
TAG
LOW
LOW
O G P
RS
CH
SQL
3
3
15