Table of Contents
Advertisement
Message List
When the printer cannot continue printing for some reason (an error status), the
printer beeps, the
indicates the description of the error appears in the display. A Warning message
appears in the display when the printer requires some remedy (a warning status)
although the job is not affected.
If either of these messages appears, perform the following procedures according to
the message.
NOTE
When multiple warnings are occurring at the same time, the Warning messages appear
•
by rotation.
When the printer is in error status and warning status at the same time, the Warning
•
message does not appear.
Even when a message with (Warning Message) appears (when the printer is in a
•
warning status), the printer does not stop printing.
For a message with the <Auto Error Skip> mark, you can skip the error by pressing the
•
it may not be printed properly. When you want to stop the process, perform a soft reset to
eliminate the cause of the error, press the
8
you can automatically skip the errors to which this mark is attached by setting AUTO
ERROR SKIP in the SETUP menu to ON.
<E nnn-nnnn> ("n" represents a number)
Cause
Remedy
<OF OPT.CONN.ERR.>
Cause 1
Remedy
Cause 2
Remedy
8-26
Message List
(Message) indicator comes on, and an error message that
(Online) key and continue printing. However, part of the print data may be missing or
A problem has occurred inside the printer.
Solve the problem following the instructions in "Service Call Display" (See p.
8-36).
The optional paper feeder is not installed properly.
Turn the power OFF, install the paper feeder properly, and then turn it ON again.
The optional paper feeder is installed or removed when the printer is ON.
Turn the power OFF, install or remove the paper feeder, then turn the printer ON
again.
(Online) key, and then print again. Also,
Advertisement
Table of Contents
Troubleshooting
