Canon LBP 3370 User Manual page 289

Remedy 2 Perform a soft reset in the RESET menu, increase the free space of RAM using
<35 TABLE FULL>
Cause
Remedy
<38 LOW IMGE QLTY>
Cause
Remedy 1 The printer continues printing by pressing the
Remedy 2 Perform a soft reset in the RESET menu, set GRADATION LEVEL (See p. 6-24)
<39 SPL MEM.FULL>
Cause
8
Remedy 1 The printer continues printing by pressing the
Remedy 2 Perform a soft reset in the RESET menu, specify the paper size smaller, and
Remedy 3 Perform a soft reset in the RESET menu, set GRADATION LEVEL (See p. 6-24)
Remedy 4 If 2-SIDED PRINT. in the FEEDER MENU options in the SETUP menu is set to
Remedy 5 Change the setting for HALFTONES (See p. 6-26) in the QUALITY MENU
8-30 Message List
the following procedure, and then print again.
Perform a hard reset or cycle the power of the printer (Be aware that all the
•
data in the memory that the printer has received will be deleted).
The number of the documents in a job has exceeded 16.
The printer continues printing by pressing the
job with which an error has occurred is not printed.
The printer cannot process the data because it is too complicated.
printer prints with the image quality level being lowered.
in the QUALITY MENU options in the SETUP menu to STANDARD, and then
print again.
Because spool memory has run out, the printer cannot print.
page with which an error has occurred is not printed.
then print again.
in the QUALITY MENU options in the SETUP menu to STANDARD, and then
print again.
ON, specify OFF, and then print again.
options in the SETUP menu, and then print again.
<Auto Error Skip>
(Online) key. However, the
<Auto Error Skip>
(Online) key. However, the
<Auto Error Skip>
(Online) key. However, the