Canon LBP 3370 User Manual page 198

Item
Restrict the users who can print or perform the printer settings
using IP addresses.
- To reject specific users from printing, set REJECT RX/PRT to
ON, and then specify the addresses to be rejected in REJECT
ADD.SET..
- To permit specific users to print, set PERMIT RX/PRT to ON,
and then specify the addresses to be permitted in PERMIT
ADD.SET..
- To reject specific users from changing the settings, set
REJECT ADD.SET. to ON, and then specify the addresses to
be rejected in REJECT ADD.SET..
- To permit specific users to change the settings, set PERMIT
ADD.SET. to ON, and then specify the addresses to be
permitted in PERMIT ADD.SET..
Enter addresses in REJECT ADD.SET. and PERMIT ADD.SET.
using the following procedure.
IP (This section describes the setting procedure taking REJECT
ADD.RANGE ADD.SET as an example. You can also apply this procedure to
the setting for PERMIT ADD.SET..)
a Select REJECT ADD.SET., then press [OK].
b Select REJ IP 1 START, then press [OK].
c Enter the IP address to be rejected, then press [OK].
For the method for entering the addresses, see "Method for
entering addresses" below the table.
d If you enter an IP address in REJ IP 1 END, the IP addresses
between REJ IP 1 START and REJ IP 1 END are rejected.
For example, if you specify addresses as follows, 12
addresses between "192.168.0.200" and "192.168.0.211" are
rejected.
- Entering "192.168.0.200" for REJ IP 1 START
- Entering "192.168.0.211" for REJ IP 1 END
e If you want to enter other IP addresses to be rejected, enter
them starting from REJ IP 2 START.
You can enter up to eight addresses.
Specify the settings for PRIMARY ADD. and SECONDARY
ADD. for DNS.
For the method for entering the addresses, see "Method for
DNS entering addresses" below the table.
* Specify the settings for [DNS Host Name], [DNS Domain
Name], and [DNS Dynamic Update] from the Remote UI. (See
Network Guide)
IP V. 6
If you want to use IP v. 6, specify ON.
SETTING
Setting
SETUP Menu Settings
6
6-31