Configuring Static Route - ZyXEL Communications PMG5318-B20A User Manual

Chapter 13 Static Route

13.2.1 Configuring Static Route

Click Advanced > Static Route to open the Static Route screen.
Figure 63 Static Route
The following table describes the labels in this screen.
Table 45 Static Route
LABEL
#
Active
Name
Destination
Netmask
Gateway
Modify
120
DESCRIPTION
This is the number of an individual static route.
This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Click the Edit icon to go to the screen where you can set up a static route on the GPON
Device.
Click the Remove icon to remove a static route from the GPON Device. A window displays
asking you to confirm that you want to delete the route.
PMG5318-B20A User's Guide