ZyXEL Communications PMG5318-B20A User Manual page 29

Table 5 Internet Access Setup - PPPoE (continued)
LABEL
802.1Q VLAN ID
802.1P Priority
Method
WAN service type
Enable WAN
Connection Limit
Connection Number
IGMP Proxy
Configuration
LAN IGMP version
WAN IGMP version
Query Interval
Connection
Always-on
Connect Demand
Feature
Enable NAT
Enable ICMP
Enable IP Conflict
Detection
IPv4 IP Address
Obtain an IP Address
Automatically
Static IP Address
IPv4 DNS Server
PMG5318-B20A User's Guide
DESCRIPTION
This shows the VLAN ID assigned to traffic for this connection. Click Edit to open a
screen where you can select a different VLAN ID. See
information on this screen.
Select the 802.1P priority method to be assigned to traffic sent through this
connection.
If you select PPPoE or IP in the WAN service type field above, select which type of
traffic (Data, VoIP, Management, and/or IPTV) can use this WAN interface.
This field displays Bridge if you select Bridge in the WAN service type field above.
Select Enable WAN Connection Limit to limit the number of connections for a
service type.
If you select Enable WAN Connection Limit, you can specify the maximum number
of connections. For a low priority service type, you can set this number to a lower
value.
Select the IGMP version to be used for IGMP messages originating from the LAN.
Select the IGMP version to be used for IGMP messages originating from the WAN.
Enter the time period in seconds between general queries. A general query is a
message sent to learn the multicast reception state of the device attached to the
interface.
Select Always-on when you want your connection up all the time. The GPON Device
will try to bring up the connection automatically if it is disconnected.
Select Connect Demand when you don't want the connection up all the time and
specify an idle time-out in the Max Idle Timeout field.
Select this check box to activate NAT on this connection.
Internet Control Message Protocol is a message control and error-reporting protocol
between a host server and a gateway to the Internet. ICMP uses Internet Protocol
(IP) datagrams, but the messages are processed by the TCP/IP software and directly
apparent to the application user.
Select this check box to reply to incoming WAN Ping requests. If this is not enabled,
the GPON Device will not respond to any incoming Ping requests.
Select this to have the GPON Device detect if the IP address assigned to this WAN
interface conflicts with other WAN IP addresses.
A dynamic IP address is not fixed; the ISP assigns a different one each time you
connect to the Internet.
Select Obtain an IP Address Automatically to get a dynamic IPv4 address for this
WAN.
A static IP address is a fixed IP that the ISP provides.
Select Static IP Address and type the ISP assigned information in the field below.
Chapter 4 WAN
Section 4.3.4 on page 37 for
29