General Setup - ZyXEL Communications PMG5318-B20A User Manual

Chapter 16 System

16.2 General Setup

Use this screen to configure the GPON Device's system name, inactivity timer, and password. Click
Maintenance > System to open the General screen.
Figure 72 System > General
The following table describes the labels in this screen.
Table 53 System > General Setup
LABEL
General Setup
System Name
Administrator
Inactivity Timer
Password
Old Password
New Password
Retype to Confirm Type the new password again for confirmation.
Apply
Cancel
138
DESCRIPTION
Choose a descriptive name for identification purposes. It is recommended you enter your
computer's "Computer name" in this field. This name can be up to 30 alphanumeric
characters long. Spaces are not allowed, but dashes "-" and underscores "_" are
accepted.
Type how many minutes a management session (either via the web configurator or
telnet) can be left idle before the session times out. The default is 5 minutes. After it
times out you have to log in with your password again. Very long idle timeouts may have
security risks. A value of "0" means a management session never times out, no matter
how long it has been left idle (not recommended).
Type the default password or the existing password you use to access the system in this
field.
Type your new system password (up to 30 characters). Note that as you type a password,
the screen displays a (*) for each character you type. After you change the password, use
the new password to access the GPON Device.
Click Apply to save your changes back to the GPON Device.
Click Cancel to begin configuring this screen afresh.
PMG5318-B20A User's Guide