Table of Contents
Advertisement
Chapter 18 Tools
After you see a "restore configuration successful" screen, you must then wait one minute before
logging into the GPON Device again.
The GPON Device automatically restarts in this time causing a temporary network disconnect.
If you uploaded the default configuration file you may need to change the IP address of your
computer to be in the same subnet as that of the default device IP address (10.0.0.138).
If the upload was not successful, the following screen will appear. Click Return to go back to the
Configuration screen.
18.3.3 Reset to Factory Defaults
Click the Reset button to clear all user-entered configuration information and return the GPON
Device to its factory defaults. You can also press the RESET button on the rear panel to reset the
factory defaults of your GPON Device.
18.4 Restart
System restart allows you to reboot the GPON Device without turning the power off. Click
Maintenance > Tools > Restart. Click Restart to have the GPON Device reboot. This does not
affect the GPON Device's configuration.
Figure 79 Restart Screen
148
PMG5318-B20A User's Guide
Hide quick links:
Advertisement
Table of Contents
