Static Route Edit - ZyXEL Communications PMG5318-B20A User Manual

Table 45 Static Route (continued)
LABEL
Apply
Cancel

13.2.2 Static Route Edit

Select a static route index number and click Edit. The screen shown next appears. Use this screen
to configure the required information for a static route.
Figure 64 Static Route Edit
The following table describes the labels in this screen.
Table 46 Static Route Edit
LABEL
Active
Route Name
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Back
Apply
Cancel
PMG5318-B20A User's Guide
DESCRIPTION
Click this to apply your changes to the GPON Device.
Click this to return to the previously saved configuration.
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter the name of the IP static route. Leave this field blank to delete this static route.
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Click Back to return to the previous screen without saving.
Click Apply to save your changes back to the GPON Device.
Click Cancel to begin configuring this screen afresh.
Chapter 13 Static Route
121