Wan Interface Type - Bridging - ZyXEL Communications PMG5318-B20A User Manual

Chapter 4 WAN
Table 6 Internet Access Setup - IP (continued)
LABEL
Preference
Prefix
Prefix Length
Apply
Cancel

4.3.3 WAN Interface Type - Bridging

Select Bridging as the WAN interface type to open the following screen.
Figure 12 Internet Access Setup - Bridging
The following table describes the labels in this screen.
Table 7 Internet Access Setup - Bridging
LABEL
General
WAN interface type
Bridging LAN ports
Service
Service Description
802.1Q VLAN ID
802.1P Priority
Method
WAN service type
36
DESCRIPTION
This field displays the router preference (Low, Medium or High) the gateway
assigned to the GPON Device. The GPON Device sends this preference in the router
advertisements to tell hosts what preference they should use for the GPON Device.
This helps hosts to choose their default router especially when there are multiple IPv6
routers in the network.
Note: Make sure the hosts also support router preference to make this function work.
Enter the IPv6 prefix provided by your ISP.
Enter the bit number of the IPv6 subnet mask provided by your ISP.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select Bridging as the method of encapsulation used by your ISP from the drop-
down list box.
Select one or more LAN or wireless port(s) to bind with this WAN connection. Only the
selected ports here can use this WAN connection.
Enter a description to identify this WAN interface.
This shows the VLAN ID assigned to traffic for this connection. Click Edit to open a
screen where you can select a different VLAN ID. See
information on this screen.
Select the 802.1P priority method to be assigned to traffic sent through this
connection.
This field displays Bridge.
Section 4.3.4 on page 37 for
PMG5318-B20A User's Guide