The Wps Button; Using The Wps Button - ZyXEL Communications PMG5318-B20A User Manual

To set the device back to the factory default settings, press the RESET button for more than 3
2
seconds or until the POWER LED begins to blink and then release it. When the POWER LED begins
to blink, the defaults have been restored and the device restarts.

1.7 The WPS Button

You can use the WPS button on the back of the device to disable or activate the wireless LAN. You
can also use it to activate WPS in order to quickly set up a wireless network with strong security.
Figure 5 WPS Button

1.7.1 Using the WPS button

Make sure the POWER LED is on (not blinking).
1
If the wireless LAN of the GPON Device is enabled, the LED light shines green. If not, press the
2
WPS button for more than 5 seconds and release it when the LED turns green. If you want to turn
it off, press the WPS button for 5 seconds again.
Press the WPS button for over 5 seconds and release it. See above for WPS button location.
3
Press the WPS button on a compatible device within 2 minutes of pressing the button on the GPON
4
Device. The WLAN LED should flash in orange while the GPON Device sets up a WPS connection
with the other wireless device.
Once the connection is successfully made, the WLAN LED shines green.
5
PMG5318-B20A User's Guide
Chapter 1 Introduction
13