The Wps Screen - ZyXEL Communications PMG5318-B20A User Manual

Chapter 6 Wireless LAN

6.4 The WPS Screen

Use this screen to configure WiFi Protected Setup (WPS) on your GPON Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS.
Click Network > Wireless LAN > WPS. The following screen displays.
Figure 24 Network > Wireless LAN > WPS
The following table describes the labels in this screen.
Table 18 Network > Wireless LAN > WPS
LABEL
WPS Setup
Enable WPS
PIN Number
WPS Status
Release
Apply
Cancel
52
DESCRIPTION
Select the check box to activate WPS on the GPON Device.
The PIN of the GPON Device is shown here. Enter this PIN in the configuration utility of
the device you want to connect to using WPS.
The PIN is not necessary when you use WPS push-button method.
Click the Generate button to have the Device create a new PIN.
This displays Configured when the GPON Device has connected to a wireless network
using WPS or Enable WPS is selected and wireless or wireless security settings have
been changed. The current wireless and wireless security settings also appear in the
screen.
This displays Unconfigured if WPS is disabled and there is no wireless or wireless
security changes on the GPON Device or you click Release to remove the configured
wireless and wireless security settings.
This button is available when the WPS status is Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the GPON Device.
Click this to save your changes.
Click this to restore your previously saved settings.
PMG5318-B20A User's Guide