The Ip And Dhcp Screen - ZyXEL Communications PMG5318-B20A User Manual

Chapter 5 LAN

5.2 The IP and DHCP Screen

Click Network > LAN to open the IP & DHCP screen. Use this screen to set the Local Area
Network IP address and subnet mask of your GPON Device.
Figure 16 LAN & DHCP
The following table describes the fields in this screen.
Table 10 IP & DHCP
LABEL
LAN TCP/IP
IP Address
IP Subnet Mask
DHCP Setup
DHCP
IP Pool Starting
Address
40
DESCRIPTION
Enter the LAN IP address you want to assign to your GPON Device in dotted decimal
notation, for example, 192.168.1.1 (factory default).
Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your GPON Device automatically computes the
subnet mask based on the IP Address you enter, so do not change this field unless you
are instructed to do so.
Select whether to have the GPON Device act as a DHCP Server.
Select Server to have the GPON Device assign IP addresses and provide subnet mask,
gateway, and DNS server information to the network. The GPON Device is the DHCP
server for the network.
Otherwise, select Disable to not have the GPON Device provide any DHCP services.
The DHCP server will be disabled.
This field specifies the first of the contiguous addresses in the IP address pool.
PMG5318-B20A User's Guide